Cisco NCS 4000 Series Hardware Installation page 287

Removing and Replacing Chassis Components
• Make sure that the ECUis installed. See the
Required Tools and Equipment
• ESD-preventive wrist strap
• 6-inch, number-1 Phillips screwdriver
• SSDs (Cisco PID NCS4K-SSD-100G or NCS4K-SSD-200G=)
Steps
To remove an SSD:
Procedure
Step 1
Loosen the two captive screws.
Figure 140: Captive Screws on the SSD
1
Step 2
Slide out the SSD from the ECUslot.
Captive screws
Routing the BITS Cables, on page
Hardware Installation Guide for Cisco NCS 4000 Series
Replacing an SSD
265.
267