20-Port 10Ge Otn Line Card - Cisco NCS 4000 Series Hardware Installation

20-Port 10GE OTN Line Card

Table 11: 24-Port Low-Rate OTN LC Descriptions
LED
Status
Attention
Port
5 The Attention LED can be lit only by using the hw-module attention-led location CLI command, which is useful for identifying and verifying which card needs
attention.
Physical Characteristics
• Height—11.05 in. (280.6 mm)
• Width—1.55 in. (39.4 mm)
• Depth—14.25 in. (362 mm)
• Weight—5.5 lb (2.5 kg)
20-Port 10GE OTN Line Card
The 20-port 10GE OTN LC (NCS4K-20T-O-S) line card supports any combination of the following interfaces,
up to:
• Twenty 10GE interfaces through SFP+ pluggable optics
• Twenty OC-192/STM-64 interfaces through SFP+ pluggable optics
• Twenty OTU2 interfaces through SFP+ pluggable optics
Hardware Installation Guide for Cisco NCS 4000 Series
78
State
Green
Yellow
Off
5
Blue
Off
Green
Yellow
Off
Installing Route Processor Cards, Fabric Cards, and Line Cards
Description
The LC is properly seated and
operating correctly.
The LC has one or more errors
detected.
No power is applied to the LC.
The card needs attention.
The card does not need attention.
The link is up (including internal
loopback).
The link is down or a hardware
failure has occurred.
The slice is unprovisioned by
software, the optics module is
missing, or the slice has been
powered down.