Removing The Chassis Ground Cable - Cisco NCS 4000 Series Hardware Installation

Removing the Chassis Ground Cable

Procedure
Step 1 Use the screwdriver to loosen the two screws that attach each power tray to the chassis.
Figure 126: Removing a Power Tray from the Chassis
Step 2 Slide the power tray all the way out of the chassis, fully supporting it during removal. You can use the vertical
slot dividers to grip the unit.
Caution
Removing the Chassis Ground Cable
This section describes how to remove the chassis ground cable on the Cisco NCS 4009 chassis.
Hardware Installation Guide for Cisco NCS 4000 Series
248
Because of the weight of the power tray, and the height at which the power tray is installed in the
chassis, you should be especially careful while removing and carrying the power tray. To prevent
injury, avoid sudden twists or lateral moves.
Removing and Replacing Chassis Components