Installing a Fabric Card
Step 10 Use the number-2 Phillips screwdriver or number-2 common (flat-head) screwdriver to turn the two captive
screws on the front panel of the card clockwise to seat the card firmly in the slot. Tighten the captive screws
using 10.60 pound/force (lbf) inch (1.20 Nm torque).
Step 11 Before attaching the vertical cable management bracket, ensure that the FC has been installed properly. See
the
Verifying the Installation of a Fabric Card, on page
Step 12 Attach the vertical cable management bracket to the faceplate of the FC using the two screws that came with
it. The dark gray arm should be facing up and the light gray arm should be facing down. See the following
figure.
Figure 33: Attaching the Vertical Cable Management Bracket
1
Hardware Installation Guide for Cisco NCS 4000 Series
66
Installing Route Processor Cards, Fabric Cards, and Line Cards
Light gray arm
2
67.
Dark gray arm