Hardware Installation Guide For Cisco Ncs 4000 Series - Cisco NCS 4000 Series Hardware Installation

Installing Route Processor Cards, Fabric Cards, and Line Cards
The following steps describe how to install an LC.
Figure 41: Installing an LC
Procedure
Step 1 Attach the ESD-preventive wrist strap to your wrist and connect its leash to the ESD jack located on the front
or rear of the chassis. You can also connect the ESD-preventive wrist strap leash to any bare metal surface
on the chassis.
Step 2 Remove the filler card (see the Removing a Filler Card, on page

Hardware Installation Guide for Cisco NCS 4000 Series

Installing a Line Card
55) and set it aside.
87