Port 100Ge Otn Line Card - Cisco NCS 4000 Series Hardware Installation

2-Port 100GE OTN Line Card

Table 32: 20-Port 10GE OTN LC Descriptions
LED
Status
Attention
Port
15 The Attention LED can be lit only by using the hw-module attention-led location CLI command, which is useful for identifying and verifying which card needs
attention.
Physical Characteristics
• Height—11.05 in. (280.6 mm)
• Width—1.55 in. (39.4 mm)
• Depth—14.25 in. (362 mm)
• Weight—5.5 lb (2.5 kg)
2-Port 100GE OTN Line Card
The 2-port 100GE OTN LC (NCS4K-2H-O-K) supports any combination of 100GE and OTU4 interfaces
using Cisco CPAK pluggable optics. Two CPAK receptacles are hosted on the faceplate.
Insert CPAK modules in the 2-port 100GE OTN LC handle side down.
Note
Hardware Installation Guide for Cisco NCS 4000 Series
218
State
Green
Yellow
Off
15
Blue
Off
Green
Yellow
Off
Installing Route Processor Cards, Fabric Cards, and Line Cards
Description
The LC is properly seated and
operating correctly.
The LC has one or more errors
detected.
No power is applied to the LC.
The card needs attention.
The card does not need attention.
The link is up (including internal
loopback).
The link is down or a hardware
failure has occurred.
The slice is unprovisioned by
software, the optics module is
missing, or the slice has been
powered down.