Performing Online Insertion And Removal Of Fan Tray - Cisco NCS 4000 Series Hardware Installation

Removing and Replacing Chassis Components

Performing Online Insertion and Removal of Fan Tray

Procedure
Step 1 Open the front door of chassis by unlocking the ejector lever.
Step 2 Loosen the two thumb screws on the plastic grill. See
on page
Figure 67: Location of Thumb Screws on Plastic Grill
1
Step 3 Remove the plastic grill from chassis by pressing the tabs in the chassis and place it in secure place.
Step 4 Place the trap door in chassis in the same area from where the plastic grill was removed.
129.
Screws on either side of the plastic grill
Performing Online Insertion and Removal of Fan Tray
Figure 67: Location of Thumb Screws on Plastic Grill,
Hardware Installation Guide for Cisco NCS 4000 Series
129