Installing A Line Card - Cisco NCS 4000 Series Hardware Installation

Installing a Line Card

Pluggable
CFP2
Installing a Line Card
This section contains the following procedures:
Installing a Line Card
Prerequisites
Before performing this task, open the front door, if installed.
Remove or install only one LC at a time. Allow at least 30 seconds for the chassis to complete its tasks
Caution
before removing or installing another LC. The chassis may indicate a hardware failure if you do not follow
proper procedures.
Required Tools and Equipment
• ESD-preventive wrist strap
• Number-2 Phillips screwdriver or number-2 common (flat-head) screwdriver
• LC
Steps
Hardware Installation Guide for Cisco NCS 4000 Series
224
Rate and Reach Product ID
100G QPSK / CFP2
200G 16-QAM
- WDM CFP2
Pluggable
Installing Route Processor Cards, Fabric Cards, and Line Cards
24-Port 20-Port 2-Port
Low-Rate 10GE OTN 100GE OTN
OTN LC LC LC
- - -
NCS4K-4H-OPW-QC2
LC
X