Installation Roadmap For Ncs 4009; Installation Roadmap - Cisco NCS 4000 Series Hardware Installation

Installation Roadmap for NCS 4009

This chapter lists the steps to install the Cisco NCS 4009 chassis and its components and prepare the system
for operation.
•

Installation Roadmap

This table lists the steps to install the Cisco NCS 4009 chassis and its components and prepare the system for
operation. Use this table as a checklist to ensure that all components are properly installed in the correct order.
For information about a step, see the respective book or section of this installation guide.
Table 23: Overview of Installation Steps
Step
Verify that the chassis is secured in the rack.
Note
Ground the chassis.
Verify that the power components are installed.
Verify that the ECU is installed.
Verify that the fan trays are installed.
Connect the AC or DC power cord.
Power on the chassis.
Install cards and remaining components in the chassis.
Re-install the cosmetic door.
Installation Roadmap, page 147
For ease of installation, the cosmetic door
should be removed.
9
C H A P T E R
See
Cisco Network Convergence System 4000 Series
Unpacking, Moving, and Securing Guide
Installing the Chassis Ground Cable, on page 169
Installing Power Components, on page 163
Removing the Fan Tray, on page 257
Disconnecting AC or DC Power, on page 189
Powering On the Chassis, on page 191
Installing Route Processor Cards, Fabric Cards, and
Line Cards, on page 193
Replacing the Front Door, on page 251
Hardware Installation Guide for Cisco NCS 4000 Series
147