Installing Route Processor Cards, Fabric Cards, and Line Cards
Verifying the Installation of a Fabric Card
Figure 34: FC Front Panel
1
2
Use the Status LED, located on the faceplate of the FC, to verify the correct installation of the card:
• When the card is properly installed and no faults are detected, the card status LED turns green.
• When the card status LED is solid yellow, either software initialization is in progress during bootup or
Status LED
Attention LED
a fault exists on the board.
Verifying the Installation of a Fabric Card
3
Hardware Installation Guide for Cisco NCS 4000 Series
Port LEDs (one per port)
67