Removing An Rp Card - Cisco NCS 4000 Series Hardware Installation

Removing and Replacing Chassis Components
Procedure
Step 1 Perform the procedure
replaced/reinserted.
Step 2
Perform the procedure
was removed in step1.
Step 3 In the Node View of CTC, click the Inventory tab.
Step 4
if Admin State of the line card is OOS (Out of Service) in CTC, then set the Admin State of the line card
to IS (In Service).
Traffic will resume after the card is in service.

Removing an RP Card

This section describes how to remove a route processor card from the Cisco NCS 4009 chassis.
Prerequisites
Before performing this task, open the front door, if installed. The RP cards are hot-swappable.
Perform this task when you are certain that the other RP card in the chassis is operational and, if not already
the active RP, is ready to assume control (this happens automatically). Failure to follow these guidelines can
result in interruptions in data communications and network connectivity.
Class 1 Laser Product. Statement 113
Warning
Because invisible radiation may be emitted from the aperture of the port when no fiber cable is
Warning
connected, avoid exposure to radiation and do not stare into open apertures. Statement 125
Required Tools and Equipment
• ESD-preventive wrist strap
• Number-2 Phillips screwdriver or number-2 common (flat-head) screwdriver
Removing a Line Card, on page 235
Installing a Line Card, on page 224
Hardware Installation Guide for Cisco NCS 4000 Series
Removing an RP Card
to remove the line card that needs to be
to install a new card or reinsert the same card that
239