Replacing Or Reinserting A Line Card - Cisco NCS 4000 Series Hardware Installation

Replacing or Reinserting a Line Card

Step 6 Grasp the two card ejector levers and simultaneously pivot both ejector levers 70 degrees away from the front
edge of the card carrier to unseat the card from the backplane connector.
Step 7 Touching only the metal card carrier, slide the card from the slot and place it directly into an antistatic sack
or other ESD-preventive container.
Warning
Replacing or Reinserting a Line Card
This section describes how to replace or reinsert a line card on the Cisco NCS 4009 chassis.
Class 1 Laser Product. Statement 113
Warning
Warning Because invisible radiation may be emitted from the aperture of the port when no fiber cable is
connected, avoid exposure to radiation and do not stare into open apertures. Statement 125
Warning For diverging beams, viewing the laser output with certain optical instruments within a distance of
100 mm may pose an eye hazard. For collimated beams, viewing the laser output with certain optical
instruments designed for use at a distance may pose an eye hazard. Statement 282
Prerequisites
Before performing this task, open the front door, if installed.
Remove or install only one LC at a time. Allow at least 30 seconds for the chassis to complete its tasks
Caution
before removing or installing another LC. The chassis may indicate a hardware failure if you do not follow
proper procedures.
This procedure is traffic-impacting.
Required Tools and Equipment
• ESD-preventive wrist strap
• Number-2 Phillips screwdriver or number-2 common (flat-head) screwdriver
• LC
Steps
To replace/reinstall the line card:
Hardware Installation Guide for Cisco NCS 4000 Series
238
Because invisible laser radiation may be emitted from the aperture of the port when no
cable is connected, avoid exposure to laser radiation and do not stare into open apertures.
Statement 70
Removing and Replacing Chassis Components