Xstatus Systemunit Hardware Module Compatibilitylevel; Xstatus Systemunit Hardware Mainboard Serialnumber; Xstatus Systemunit Hardware Mainboard Identifier; Xstatus Systemunit Hardware Monitoringsoftware - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80
Contents Introduction

xStatus SystemUnit Hardware Module CompatibilityLevel

The Cisco TelePresence endpoints are using a NAND flash memory for general storage. The
endpoints running TC software are manufactured with a new version of the flash memory. Endpoints
having the new version of the flash memory must run software TC4.2.1 or later. Some previous TC
software versions are updated to support the new flash memory. Please check the release note
to find if the new version of the flash memory is supported. If your endpoint does not have the
CompatibilityLevel command it does not have the new flash memory installed.
The result returned when running the command is either 0 or 1:
0 = The system does not have the new flash memory installed.
1 = The system has the new flash memory installed. If downgraded, it can only be downgraded to
previous TC software versions having support for the new version of the flash memory.
Value space of the result returned:
<"1"/"0">
Example:
xStatus SystemUnit Hardware Module CompatibilityLevel
*s SystemUnit Hardware Module CompatibilityLevel: 1
** end

xStatus SystemUnit Hardware MainBoard SerialNumber

Shows the serial number of the main board in the codec.
Value space of the result returned:
<String>
Example:
xStatus SystemUnit Hardware MainBoard SerialNumber
*s SystemUnit Hardware MainBoard SerialNumber: "F1234567"
** end

xStatus SystemUnit Hardware MainBoard Identifier

Shows the revision of the main board in the codec.
Value space of the result returned:
<String>
Example:
xStatus SystemUnit Hardware MainBoard Identifier
*s SystemUnit Hardware MainBoard Identifier: "101400-5 [06]"
** end
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration

xStatus SystemUnit Hardware MonitoringSoftware

xStatus SystemUnit Hardware Temperature

xStatus SystemUnit Hardware TemperatureThreshold

211
xCommand
The feedback shows the monitoring software id.
Value space of the result returned:
<String>
Example:
xStatus SystemUnit Hardware MonitoringSoftware
*s SystemUnit Hardware MonitoringSoftware: "39"
** end
The feedback shows the current maximum temperature (degree Celsius) measured in the codec/
system.
Value space of the result returned:
<String>
Example:
xStatus SystemUnit Hardware Temperature
*s SystemUnit Hardware Temperature: "64.0"
** end
Returns information on the maximum temperature for the codec. If this temperature is exceeded the
system automatically shuts down.
Value space of the result returned:
<String>
Example:
xStatus SystemUnit Hardware TemperatureThreshold
*s SystemUnit Hardware TemperatureThreshold: "85"
** end
API Reference Guide
xStatus xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.