Cisco TelePresence SX80 Reference Manual page 54

Cisco TelePresence SX80
Contents Introduction
xConfiguration Network [1..1] TrafficControl Mode
Set the network traffic control mode to decide how to control the video packets transmission speed.
Requires user role: ADMIN
Value space: <Off/On>
Off: Transmit video packets at link speed.
On: Transmit video packets at maximum 20 Mbps. Can be used to smooth out bursts in the outgo-
ing network traffic.
Example: xConfiguration Network 1 TrafficControl: On
xConfiguration Network [1..1] RemoteAccess Allow
Define which IP addresses (IPv4/IPv6) are allowed for remote access to the codec from SSH/
Telnet/HTTP/HTTPS. Multiple IP addresses are separated by a white space.
A network mask (IP range) is specified by <ip address>/N, where N is 1-32 for IPv4, and N is 1-128
for IPv6. The /N is a common indication of a network mask where the first N bits are set. Thus
192.168.0.0/24 would match any address starting with 192.168.0, since these are the first 24 bits in
the address.
Requires user role: ADMIN
Value space: <S: 0, 255>
Format: String with a maximum of 255 characters.
Example: xConfiguration Network 1 RemoteAccess Allow: "10.11.2.3 192.168.0.0/24
2001:0db8:0000:0000:0000:ff00:0042:8329 2001:db8:abcd:0012::0/64"
xConfiguration Network [1..1] VLAN Voice Mode
Set the VLAN voice mode. The VLAN Voice Mode will be set to Auto automatically if you have Cisco
UCM (Cisco Unified Communications Manager) as provisioning infrastructure. Note that Auto mode
will NOT work if the NetworkServices CDP Mode setting is Off.
Requires user role: ADMIN
Value space: <Auto/Manual/Off>
Auto: The Cisco Discovery Protocol (CDP), if available, assigns an id to the voice VLAN. If CDP is
not available, VLAN is not enabled.
Manual: The VLAN ID is set manually using the Network VLAN Voice VlanId setting. If CDP is avail-
able, the manually set value will be overruled by the value assigned by CDP.
Off: VLAN is not enabled.
Example: xConfiguration Network 1 VLAN Voice Mode: Auto
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration xConfiguration
xConfiguration Network [1..1] VLAN Voice VlanId
54
xCommand
Set the VLAN voice ID. This setting will only take effect if VLAN Voice Mode is set to Manual.
Requires user role: ADMIN
Value space: <1..4094>
Range: Select a value between 1 and 4094.
Example: xConfiguration Network 1 VLAN Voice VlanId: 1
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.