Systemunit Configuration - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80
Contents Introduction

SystemUnit configuration

xConfiguration SystemUnit Name
Define the system name. The system name will be sent as the hostname in a DHCP request and
when the codec is acting as an SNMP Agent.Define the system name. The system name will be
sent as the hostname in a DHCP request and when the codec is acting as an SNMP Agent.
Requires user role: ADMIN
Value space: <S: 0, 50>
Format: String with a maximum of 50 characters.
Example: xConfiguration SystemUnit Name: "Meeting Room"
xConfiguration SystemUnit MenuLanguage
This has been replaced with the UserInterface Language setting.
xConfiguration SystemUnit CallLogging Mode
Set the call logging mode for calls that are received or placed by the system. The call logs may then
be viewed via the web interface or using the xCommand CallHistory Get command.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable logging.
On: Enable logging.
Example: xConfiguration SystemUnit CallLogging Mode: On
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration xConfiguration
xConfiguration SystemUnit ContactInfo Type
xConfiguration SystemUnit IrSensor
70
xCommand
Choose which type of contact information to show in the status field in the upper left corner of the
main display and Touch controller. The information can also be read with the command xStatus
SystemUnit ContactInfo.
Requires user role: ADMIN
Value space: <Auto/None/IPv4/IPv6/H323Id/E164Alias/H320Number/SipUri/SystemName/
DisplayName>
Auto: Show the address which another system can dial to reach this system. The address
depends on the default call protocol and system registration.
None: Do not show any contact information in the status field.
IPv4: Show the IPv4 address as contact information.
IPv6: Show the IPv6 address as contact information.
H323Id: Show the H.323 ID as contact information (see the H323 Profile [1..1] H323Alias ID setting).
E164Alias: Show the H.323 E164 Alias as contact information (see the H323 Profile [1..1] H323Alias
E164 setting).
H320Number: Show the H.320 number as contact information (only applicable if connected to a
Cisco TelePresence ISDN Link gateway).
SipUri: Show the SIP URI as contact information (see the SIP Profile [1..1] URI setting).
SystemName: Show the system name as contact information (see the SystemUnit Name setting).
DisplayName: Show the display name as contact information (see the SIP Profile [1..1]
DisplayName setting).
Example: xConfiguration SystemUnit ContactInfo Type: Auto
Not applicable in this version.
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.