Experimental Configuration - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80
Contents Introduction
xConfiguration Video Output Connector [1..3] Resolution
Set the resolution and refresh rate for the connected screen.
Requires user role: ADMIN
Value space: <Auto/1280_720_50/1280_720_60/1920_1080_50/1920_1080_60>
Auto: The system will automatically try to set the optimal resolution based on negotiation with the
connected monitor.
1280_720_50: The resolution is 1280 x 720, and the refresh rate is 50 Hz.
1280_720_60: The resolution is 1280 x 720, and the refresh rate is 60 Hz.
1920_1080_50: The resolution is 1920 x 1080, and the refresh rate is 50 Hz.
1920_1080_60: The resolution is 1920 x 1080, and the refresh rate is 60 Hz.
Example: xConfiguration Video Output Connector 2 Resolution: Auto
xConfiguration Video Output Connector [1..3] MonitorRole
The monitor role describes which video streams will be shown on the monitor connected to this
video output connector. Together the Video Monitors setting and the MonitorRole settings for all
outputs define which layout (video streams) will be shown on each monitor.
Requires user role: ADMIN
Value space: <Auto/First/Second/Third/PresentationOnly/Recorder>
Auto: The system will detect when a monitor is connected, and a monitor role (First, Second,
Third) that corresponds with the Video Monitors setting will be assigned automatically.
First/Second/Third: Define the role of the monitor in a multi-monitor setup. In a single-monitor
setup, there is no difference between First, Second and Third.
PresentationOnly: Show presentation video stream if active, and nothing else. Monitors/outputs
with this monitor role are disregarded by the Video Monitors setting.
Recorder: Show all participants, including the local main video (self-view). If active, also show
the presentation. Monitors/outputs with this monitor role are disregarded by the Video Monitors
setting.
Example: xConfiguration Video Output Connector 1 MonitorRole: Auto
xConfiguration Video WallPaper
This has been replaced with the UserInterface Wallpaper setting.
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration xConfiguration

Experimental configuration

The Experimental settings are for testing only and should not be used unless agreed with Cisco.
These settings are not documented and WILL change in later releases.
82
xCommand xStatus
Copyright © 2015 Cisco Systems, Inc. All rights reserved.
API Reference Guide
Appendices