Cisco TelePresence SX80 Reference Manual page 41

Cisco TelePresence SX80
Contents Introduction
xConfiguration Conference [1..1] FarEndControl Mode
Lets you decide if the remote side (far end) should be allowed to select your video sources and
control your local camera (pan, tilt, zoom).
Requires user role: ADMIN
Value space: <Off/On>
Off: The far end is not allowed to select your video sources or to control your local camera (pan,
tilt, zoom).
On: Allows the far end to be able to select your video sources and control your local camera (pan,
tilt, zoom). You will still be able to control your camera and select your video sources as normal.
Example: xConfiguration Conference 1 FarEndControl Mode: On
xConfiguration Conference [1..1] FarEndControl SignalCapability
Set the far end control (H.224) signal capability mode.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable the far end control signal capability.
On: Enable the far end control signal capability.
Example: xConfiguration Conference 1 FarEndControl SignalCapability: On
xConfiguration Conference [1..1] Encryption Mode
Define the conference encryption mode. A padlock with the text "Encryption On" or "Encryption
Off" displays on screen for a few seconds when the conference starts.
NOTE: If the Encryption Option Key is not installed on the video system, the encryption mode is
always Off.
Requires user role: ADMIN
Value space: <Off/On/BestEffort>
Off: The system will not use encryption.
On: The system will only allow calls that are encrypted.
BestEffort: The system will use encryption whenever possible.
> In Point to point calls: If the far end system supports encryption (AES-128), the call will be
encrypted. If not, the call will proceed without encryption.
> In MultiSite calls: In order to have encrypted MultiSite conferences, all sites must support
encryption. If not, the conference will be unencrypted.
Example: xConfiguration Conference 1 Encryption Mode: BestEffort
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration xConfiguration
xConfiguration Conference [1..1] DefaultCall Protocol
xConfiguration Conference [1..1] DefaultCall Rate
xConfiguration Conference [1..1] MaxTransmitCallRate
41
xCommand
Set the Default Call Protocol to be used when placing calls from the system.
Requires user role: ADMIN
Value space: <Auto/H323/Sip/H320>
Auto: Enables auto-selection of the call protocol based on which protocols are available. If multiple
protocols are available, the order of priority is: 1) SIP; 2) H323; 3) H320. If the system cannot
register, or the call protocol is not enabled, the auto-selection chooses H323.
H323: All calls are set up as H.323 calls.
Sip: All calls are set up as SIP calls.
H320: All calls are set up as H.320 calls (only applicable if connected to a Cisco TelePresence
ISDN Link gateway).
Example: xConfiguration Conference 1 DefaultCall Protocol: Auto
Set the Default Call Rate to be used when placing calls from the system.
Requires user role: ADMIN
Value space: <64..6000>
Range: Select a value between 64 and 6000 kbps.
Example: xConfiguration Conference 1 DefaultCall Rate: 1920
Specify the maximum transmit bit rate to be used when placing or receiving calls. Note that this is
the maximum bit rate for each individual call; use the Conference MaxTotalTransmitCallRate setting
to set the aggregated maximum for all simultaneous active calls.
Requires user role: ADMIN
Value space: <64..6000>
Range: Select a value between 64 and 6000 kbps.
Example: xConfiguration Conference 1 MaxTransmitCallRate: 6000
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.