Cisco TelePresence SX80 Reference Manual page 93

Cisco TelePresence SX80
Contents Introduction
xCommand Audio LocalOutput RemoveConnector
Detach an output connector from the local output given by the output ID. A connector is defined by
its type and ID.
This command is mainly intended for internal use by the TC console. TC console automatically
generates a start-up script that makes the command persistent over a reboot. To use this command
outside of TC console, you have to include it in a start-up script in order to make the setting persis-
tent over a reboot. For more information on star-up scripts and TC console see the administrator
guide for your codec.
OutputId: A unique identifier for the local output.
ConnectorType: Select the connector type.
ConnectorId: Select the connector.
Requires user role: ADMIN
Parameters:
OutputId(r): <0..65534>
ConnectorType(r): <HDMI/Line>
ConnectorId(r): <1..8>
Example:
xCommand Audio LocalOutput RemoveConnector OutputId:5 ConnectorType: Line
ConnectorId:1
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration
xCommand Audio LocalOutput Update
93
xCommand xCommand
Update the settings of the local output given by the output ID.
This command is mainly intended for internal use by the TC console. TC console automatically
generates a start-up script that makes the command persistent over a reboot. To use this command
outside of TC console, you have to include it in a start-up script in order to make the setting persis-
tent over a reboot. For more information on star-up scripts and TC console see the administrator
guide for your codec.
OutputId: A unique identifier for the local output.
Name: Choose a name that describes the local output.
Loudspeaker: If one or more of the output connectors are connected to a loudspeaker, this signal
should be a reference signal to the echo canceler. Hence set loudspeaker to On. NOTE: When
microphone reinforcement is disabled there should only be one loudspeaker local output.
Channels: Set channels to 1 to mix the local and remote inputs into a mono signal. To mix the inputs
into a stereo signal, set channels to 2.
VolumeControlled: Choose whether this output's volume is controlled by global audio control
(Off), or if it is at the level defined with xCommand Audio Volume Set (On). If you wish to set
VolumeControlled to Off, you must also set the parameter Loudspeaker to Off. Added in TC7.3.3.
Requires user role: ADMIN
Parameters:
OutputId(r): <0..65534>
Name(r): <S: 0, 255>
Loudspeaker(r): <On/Off>
Channels(r): <1..2>
VolumeControlled: <On/Off>
Example:
xCommand Audio LocalOutput Update OutputId: 5 Name: "Loudspeaker"
Loudspeaker: On Channels: 2
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.