Systemunit Status; Xstatus Systemunit; Xstatus Systemunit Hardware Module Compatibilitylevel; Xstatus Systemunit Hardware Module Serialnumber - Cisco TelePresence SX10 Reference Manual

Cisco TelePresence SX10

Introduction

SystemUnit status

xStatus SystemUnit

Shows the top level overview of the system unit status.

xStatus SystemUnit Hardware Module CompatibilityLevel

The Cisco TelePresence endpoints are using a NAND flash memory for general storage. The
endpoints running TC software are manufactured with a new version of the flash memory.
Endpoints having the new version of the flash memory must run software TC4.2.1 or later. Some
previous TC software versions are updated to support the new flash memory. Please check the
release note to find if the new version of the flash memory is supported. If your endpoint does
not have the CompatibilityLevel command it does not have the new flash memory installed.
The result returned when running the command is either 0 or 1:
0 = The system does not have the new flash memory installed.
1 = The system has the new flash memory installed. If downgraded, it can only be downgraded
to previous TC software versions having support for the new version of the flash memory.
Value space of the result returned:
1/0
Example:
xStatus SystemUnit Hardware Module CompatibilityLevel
*s SystemUnit Hardware Module CompatibilityLevel: 1
** end

xStatus SystemUnit Hardware Module SerialNumber

Shows the serial number of the hardware module in the codec.
Value space of the result returned:
String
Example:
xStatus SystemUnit Hardware Module SerialNumber
*s SystemUnit Hardware Module SerialNumber: "F9AA99A00090"
** end
Cisco TelePresence SX10 API Reference Guide CE8.2, SEPTEMBER 2016.
D15333.07
About the API xConfiguration xCommand

xStatus SystemUnit Hardware Monitoring Fan [n] Status

The feedback shows the speed (rpm) for the specified fan.
Value space of the result returned:
String
Example:
xStatus SystemUnit Hardware Monitoring Fan 1 Status
*s SystemUnit Hardware Monitoring Fan 1 Status: "locked on 1096 rpm"
** end

xStatus SystemUnit Hardware Temperature

Shows the current maximum temperature (degree Celsius) measured in the codec/system.
Value space of the result returned:
String
Example:
xStatus SystemUnit Hardware Temperature
*s SystemUnit Hardware Temperature: "64.0"
** end

xStatus SystemUnit Notifications Notification [n] Text

Lists text related to important system notifications. Notifications are issued e.g. when a system
was rebooted because of a software upgrade, or when a factory reset has been performed.
All the notifications can be removed from the list by issuing the xCommand SystemUnit
Notifications RemoveAll command.
Value space of the result returned:
String
Example:
xStatus SystemUnit Notifications Notification 1 Text
*s SystemUnit Notifications Notification 1 Text: "OK"
** end
167
API Reference Guide
xStatus xStatus Appendices
Copyright © 2016 Cisco Systems, Inc. All rights reserved.