Provisioning Commands - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80
Contents Introduction

Provisioning commands

xCommand Provisioning CUCM CAPF OperationStart
Starts a pending CAPF (Certificate Authority Proxy Function) operation toward the CUCM. When the
CUCM administrator initiates an operation that the endpoint should perform (like installing, updating
or deleting certificates), this command can be used to start the CAPF operation.
AuthString: Set the authentication string required for the CAPF operation.
Requires user role: USER
Parameters:
AuthString: <S: 4, 10>
Example:
xCommand Provisioning CUCM CAPF OperationStart AuthString: 123456
xCommand Provisioning CUCM CTL Delete
Delete the stored CTL and ITL files (CTL: Certificate Trust List, ITL: Identity Trust List).
Requires user role: USER
Example:
xCommand Provisioning CUCM CTL Delete
xCommand Provisioning CUCM CTL Show
Shows the content of the installed Certificate Trust List file (CTL), if it exists. Each entry displayed
contains the information about one specific certificate. If a certificate has been deleted in CTL, it is
marked accordingly in the output.
Requires user role: USER
Example:
xCommand Provisioning CUCM CTL Show
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration
xCommand Provisioning CUCM ExtensionMobility Login
xCommand Provisioning CUCM ExtensionMobility Logout
xCommand Provisioning CUCM ITL Show
xCommand Provisioning CompleteUpgrade
125
xCommand xCommand
Login command for the Extension Mobility service. You login to the Extension Mobility service with a
user name and pin. If there are multiple profiles available for that user, a separate event will be sent
with the available profiles for the user. A new login command with the profile can then be submitted.
Requires user role: USER
Parameters:
UserId(r): <S: 1, 255>
Pin(r): <S: 1, 255>
Profile: <S: 1, 255>
Example:
xCommand Provisoning CUCM ExtensionMobility Login UserId: user1 Pin: 1234
This command will log you out of your Extension Mobility profile.
Requires user role: USER
Example:
xCommand Provisioning CUCM ExtensionMobility Logout
Shows the content of the installed Identity Trust List file (ITL), if it exists. Each entry displayed
contains the information about one specific certificate. If a certificate has been deleted in CTL, it is
marked accordingly in the output.
Requires user role: USER
Example:
xCommand Provisioning CUCM ITL Show
Starts installing the software upgrade if you wish to install it before it is set to do so.
Requires user role: USER
Example:
xCommand Provisioning CompleteUpgrade
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.