Systemunit Commands - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80
Contents Introduction

SystemUnit commands

xCommand SystemUnit AdminPassword Set
Set a password for the user that is currently signed in.
Requires user role: ADMIN
Parameters:
Password(r): <S: 0, 64>
Example:
xCommand SystemUnit AdminPassword Set Password:***********
xCommand SystemUnit ConfigurationProfile CancelChange
Cancel the "ConfigurationProfile Change" command, that would otherwise take effect after next
system boot.
Requires user role: ADMIN
Example:
xCommand SystemUnit ConfigurationProfile CancelChange
xCommand SystemUnit ConfigurationProfile Change
Select a previously saved configuration profile. NOTE: Requires a restart of the codec.
Requires user role: ADMIN
Parameters:
Name(r): <S: 0, 255>
Example:
xCommand SystemUnit ConfigurationProfile Change Name:
"My _ ConfigurationProfile _ 1"
*r ConfigurationProfileChangeResult (status=OK):
Warning: New configuration profile will be active after next boot.
** end
xCommand SystemUnit ConfigurationProfile List
List configuration profiles that has been stored in the system.
Requires user role: ADMIN
Example:
xCommand SystemUnit ConfigurationProfile List
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration
xCommand SystemUnit ConfigurationProfile Remove
xCommand SystemUnit ConfigurationProfile SaveCurrentConfigurationAs
xCommand SystemUnit DateTime Get
128
xCommand xCommand
Delete a configuration profile that has been stored in the system.
Requires user role: ADMIN
Parameters:
Name(r): <S: 0, 255>
Example:
xCommand SystemUnit ConfigurationProfile Remove Name:
"My _ ConfigurationProfile _ 1"
Save the current system settings into a configuration profile. Assign a name to the new profile. The
name is the unique identifier of the profile.
Requires user role: ADMIN
Parameters:
Name(r): <S: 0, 255>
Example:
xCommand SystemUnit ConfigurationProfile SaveCurrentConfigurationAs Name:
"My _ ConfigurationProfile _ 1"
Read the time and date from the system.
Requires user role: USER
Example:
xCommand SystemUnit DateTime Get
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.