Conference Commands - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80
Contents Introduction
xCommand Cameras SpeakerTrack Whiteboard SetDistance
Set the cameras distance to the whiteboard. This information is needed by the SpeakerTrack 60 to
frame the whiteboard automatically.
Distance: Set distance to whiteboard in centimeters. Use a distance between 0-2000 cm. Use an
accurate measurement for the feature to work seamlessly.
WhiteboardId: The id set for the camera position used for the snap-to-whiteboard feature. Currently
only id 1 can be used.
Requires user role: ADMIN
Parameters:
Distance (r): <0-65534>
WhiteboardId: <0-65534>
Example:
xCommand Cameras SpeakerTrack Whiteboard SetDistance Distance:1000
WhiteboardId:123
xCommand Cameras SpeakerTrack Whiteboard StorePosition
Store the position of one of the cameras on a SpeakerTrack 60 as the Snap to Whiteboard position.
Frame the image so that there is room around the whiteboard for the speaker. To use the Snap
to Whiteboard feature it must be enabled with xConfiguration Cameras SpeakerTrack Whiteboard
Mode and tracking must be enabled with xConfiguration Cameras SpeakerTrack Mode.
Note: You must store a snap-to-whiteboard position for both cameras.
Camera: Select the camera which position you wish to store.
WhiteboardId: You can give the position an id number. Currently the only id that can be used is 1.
Requires user role: ADMIN
Parameters:
Camera (r): <Left/Right>
WhiteboardId: <0-65534>
Example:
xCommand Cameras SpeakerTrack Whiteboard StorePosition Camera:Left
WhiteboardId:123
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration

Conference commands

xCommand Conference ActiveSpeaker Reset
xCommand Conference ActiveSpeaker Set
xCommand Conference DoNotDisturb Activate
108
xCommand xCommand
Resets ActiveSpeaker. Normal voice switching is switched back on.
Requires user role: USER
Example:
xCommand Conference ActiveSpeaker Reset
For manually setting the active speaker in a conference. Overrides normal voice switching.
Target: Identifies local or remote participant.
CallId: Identifies CallID for remote participant. Only relevant if Target is set to "remote".
Requires user role: USER
Parameters:
Target(r): <local/remote>
CallId: <0..65534>
Example:
Example 1
xCommand Conference ActiveSpeaker Set Target: local
Example 2
xCommand Conference ActiveSpeaker Set Target: remote CallID: 3
This command switches on the Do Not Disturb mode, and the Timeout parameter allows you
to control when it is switched off again. It only takes effect when xConfiguration Conference
DoNotDisturb Mode is set to Timed.
When Do Not Disturb is switched on, all incoming calls are rejected and registered as missed calls.
The calling side receives a busy signal.
Timeout: The number of minutes before Do Not Disturb is switched off. If not set, Do Not Disturb
times out after 1440 minutes (24 hours).
Requires user role: USER
Parameters:
Timeout: <0..1440>
Example:
xCommand Conference DoNotDisturb Activate Timeout: 120
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.