Xcommand Camera Ramp; Xcommand Camera Triggerautofocus - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction

xCommand Camera Ramp

Move the camera in a specified direction. The camera moves at specified speed until a stop
command is issued. In a daisy chain, you need to know the CameraId for the camera you want
to address. Be aware that pan and tilt can be operated simultaneously, but no other combina-
tions. In the latter case only the first operation specified is executed. For example, if you try to
run both zoom and pan at the same time, only zoom is executed.
NOTE: You must run a stop command to stop the camera, see the example below.
Requires user role: ADMIN, USER
USAGE:
xCommand Camera Ramp CameraId:
Tilt] [TiltSpeed: TiltSpeed] [Zoom: Zoom] [ZoomSpeed: ZoomSpeed] [Focus: Focus]
where
: Integer (1..1)
CameraId
Select the camera.
: Left/Right/Stop
Pan
Move the camera to the Left or Right, followed by Stop.
: Integer (1..15)
PanSpeed
Set the pan speed.
: Down/Up/Stop
Tilt
Move the camera Up or Down, followed by Stop.
: Integer (1..15)
TiltSpeed
Set the tilt speed.
: In/Out/Stop
Zoom
Zoom the camera In or Out, followed by Stop.
: Integer (1..15)
ZoomSpeed
Set the zoom speed.
: Far/Near/Stop
Focus
Focus the camera Far or Near, followed by Stop.
SX20 Codec API Reference Guide CE8.3, JANUARY 2017.
D15316.05
About the API xConfiguration
CameraId [Pan: Pan] [PanSpeed: PanSpeed] [Tilt:
xCommand xCommand

xCommand Camera TriggerAutofocus

Trigger the auto-focus functionality. The camera must support auto-focus functionality. If the
camera is daisy chained, the CameraId is given by its place in the chain.
Requires user role: ADMIN, USER
USAGE:
xCommand Camera TriggerAutofocus CameraId:
where
: Integer (1..1)
CameraId
Select the camera to auto-focus.
122
API Reference Guide
xStatus Appendices
CameraId
Copyright © 2017 Cisco Systems, Inc. All rights reserved.