Xcommand Call Hold; Xcommand Call Ignore; Xcommand Call Join; Xcommand Call Reject - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction

xCommand Call Hold

Put a call on hold.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Hold [CallId: CallId] [Reason: Reason]
where
: Integer (0..65534)
CallId
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId.
: Conference/Transfer/Other
Reason
Internal usage only.

xCommand Call Ignore

Turns off the ringtone for the incoming call. The call can still be answered.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Ignore CallId: CallId
where
: Integer (0..65534)
CallId
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId.

xCommand Call Join

Internal usage only.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Join CallId: CallId
where
: Integer (0..65534)
CallId
SX20 Codec API Reference Guide CE8.3, JANUARY 2017.
D15316.05
About the API xConfiguration xCommand xCommand

xCommand Call Reject

Reject incoming call. If no call id is specified, all incoming calls are rejected.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Reject [CallId: CallId]
where
: Integer (0..65534)
CallId
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId.

xCommand Call Resume

Resume a call that have been put on hold.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Resume [CallId: CallId]
where
: Integer (0..65534)
CallId
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId.

xCommand Call UnattendedTransfer

Transfers an ongoing call to another participant. Fully supported for SIP calls only.
Requires user role: ADMIN, USER
USAGE:
xCommand Call UnattendedTransfer CallId:
where
: Integer (0..65534)
CallId
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId.
: String (0, 255)
Number
The number the call is transfered to.
116
API Reference Guide
xStatus Appendices
CallId Number: "Number"
Copyright © 2017 Cisco Systems, Inc. All rights reserved.