Xconfiguration Video Input Connector [1..2] Presentationselection - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction

xConfiguration Video Input Connector [1..2] PresentationSelection

Define how the video system will behave when you connect a presentation source to the video
input. In general, any input source can be used as a presentation source; normally, the main
camera will not be used as a presentation source.
If the video system is in standby mode, it will wake up when you connect a presentation source.
Sharing the presentation with the far end requires additional action (select Share on the user
interface) except when this setting is set to AutoShare.
Requires user role: ADMIN
Default value: Connector 1: Manual Connector 2: OnConnect
USAGE:
xConfiguration Video Input Connector
PresentationSelection
where
: Unique ID that identifies the video input connector. Range: 1..2
n
: Manual/OnConnect
PresentationSelection
AutoShare: While in a call, the content on the video input will automatically be presented
to the far end as well as on the local screen when you connect the cable, or when the
source is activated otherwise (for example when a connected computer wakes up from
sleep mode). You do not have to select Share on the user interface. If a presentation
source is already connected when you make or answer a call, you have to manually
select Share on the user interface.
Desktop: The content on the video input will be presented on the screen when you
connect the cable, or when the source is activated otherwise (for example when a
connected computer wakes up from sleep mode). This applies both when idle and in a
call. Also, the content on the video input will stay on the screen when you leave the call,
provided that it was the active input at the time of leaving.
Manual: The content on the video input will not be presented on the screen until you
select Share from the user interface.
OnConnect: The content on the video input will be presented on screen when you
connect the cable, or when the source is activated otherwise (for example when a
connected computer wakes up from sleep mode). Otherwise, the behavior is the same
as in manual mode.
SX20 Codec API Reference Guide CE8.3, JANUARY 2017.
D15316.05
About the API xConfiguration xConfiguration
n PresentationSelection:
xCommand
xConfiguration Video Input Connector [1..2] Visibility
Define the visibility of the video input connector in the menus on the user interface.
Requires user role: ADMIN
Default value: Connector 1: IfSignal Connector 2: Always
USAGE:
xConfiguration Video Input Connector
where
: Unique ID that identifies the video input connector. Range: 1..2
n
: Never/Always/IfSignal
Visibility
Never: When the input source is not expected to be used as a presentation source, set
to Never.
Always: When set to Always, the menu selection for the video input connector will
always be visible on the graphical user interface.
IfSignal: When set to IfSignal, the menu selection for the video input connector will only
be visible when something is connected to the video input.
100
API Reference Guide
xStatus Appendices
n Visibility: Visibility
Copyright © 2017 Cisco Systems, Inc. All rights reserved.