Conference Commands; Xcommand Conference Donotdisturb Activate; Xcommand Conference Donotdisturb Deactivate; Xcommand Conference Speakerlock Release - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction

Conference commands

xCommand Conference DoNotDisturb Activate

This command switches on the Do Not Disturb mode, and the Timeout parameter allows you to
control when it is switched off again. When Do Not Disturb is switched on, all incoming calls are
rejected and registered as missed calls. The calling side receives a busy signal.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference DoNotDisturb Activate [Timeout: Timeout]
where
: Integer (1..1440)
Timeout
Set the number of minutes before Do Not Disturb is switched off. If not set, Do Not
Disturb times out after 1440 minutes (24 hours).

xCommand Conference DoNotDisturb Deactivate

Switch off the Do Not Disturb mode. When Do Not Disturb is switched off incoming calls come
through as normal.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference DoNotDisturb Deactivate

xCommand Conference SpeakerLock Release

Releases locked speaker set by xCommand Conference SpeakerLock Set. Default voice
switching is switched back on.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference SpeakerLock Release
SX20 Codec API Reference Guide CE8.3, JANUARY 2017.
D15316.05
About the API xConfiguration xCommand xCommand

xCommand Conference SpeakerLock Set

For manually locking one of the speakers to the prominent speaker position. This overrides the
default voice switching.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference SpeakerLock Set Target:
where
: local/remote
Target
Identifies local or remote participant.
: Integer (0..65534)
CallId
Identify CallID for the remote participant. Only relevant if Target is set to "remote".
123
API Reference Guide
xStatus Appendices
Target [CallId: CallId]
Copyright © 2017 Cisco Systems, Inc. All rights reserved.