Xconfiguration Video Selfview Oncall Mode; Xconfiguration Video Selfview Oncall Duration - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction

xConfiguration Video Selfview OnCall Mode

This setting is used to switch on self-view for a short while when setting up a call. The Video
Selfview OnCall Duration setting determines for how long it remains on. This applies when self-
view in general is switched off.
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration Video Selfview OnCall Mode:
where
: Off/On
Mode
Off: self-view is not shown automatically during call setup.
On: self-view is shown automatically during call setup.

xConfiguration Video Selfview OnCall Duration

This setting only has an effect when the Video Selfview OnCall Mode setting is switched On. In
this case, the number of seconds set here determines for how long self-view is shown before it
is automatically switched off.
Requires user role: ADMIN
Default value: 10
USAGE:
xConfiguration Video Selfview OnCall Duration:
where
: Integer (1..60)
Duration
Range: Choose for how long self-view remains on. The valid range is between 1 and 60
seconds.
SX20 Codec API Reference Guide CE8.3, JANUARY 2017.
D15316.05
About the API xConfiguration xConfiguration
Mode
Duration
xCommand
105
API Reference Guide
xStatus Appendices
Copyright © 2017 Cisco Systems, Inc. All rights reserved.