Dräger Polytron 7000 Software Dongles - Dräger Polytron 7000 Instructions For Use Manual

Installing accessories
To avoid faulty measurements, pay close attention to the fitting of the sensor
in the sealing sleeve!
Removal/changing the sensor
Loosen the securing screws.

Swing the retaining clip to one side.

Pull the remote sensor out of the sealing sleeve.

Change the sensor.

Install the remote sensor again.

Dräger Polytron 7000 software dongles
Intended use
Dräger Polytron 7000 software dongle – 83 17 618, 83 17 619 or 83 17 860:
— For activating additional functions in the Dräger Polytron 7000:
Data Dongle
83 17 618
Colour-code blue
Sensor Dongle
83 17 619
Colour-code silver
Sensor Diagnostic Don-
gle
83 17 860
Colour-code green
Installing the software dongles
1 Release the measuring unit with an Allen key by turning the eccentric catch-
es counter-clockwise (
Use only a 5 mm Allen key without a ball head.
2 Push the measuring unit up to about half height and then pull it forwards out
of the docking station.
— The unit must be disconnected from the mains!
30
NOTE
— Activates the Event Logger, the Datalogger
and the graphical concentration display.
— Activates the sensor self-test.
— Activates the sensor self-test, the display of
the remaining sensor lifetime and the sensor
diagnostic function.
 o
= approx. 180 ).
NOTE
2
1