Dräger Polytron 7000 Instructions For Use Manual page 67

– Test fault
— This function simulates the fault alarm state for testing purposes.
Select the menu items » Settings «, » Instrument «, » Alarm « and » Test

fault alarm « in this order, pressing the »
— The function » Test fault status « is opened.
Select » Enable « or » Disable « and press the »

— When the function is enabled, the relay and the interfaces are set to the
fault alarm state.
Passwords
This group contains the setting functions for the passwords.
– Password Calibration
— This function is used to change the password for the menu » Calibration «.
Select the menu items » Settings «, » Instrument «, » Passwords « and

» Password Cal. « in this order, pressing the »
tion.
Select the line for password input and press the »

mode.
Use the » « and »

press the » « key to confirm the setting.
OK
Press the » « key to confirm the complete password.

OK
– Password Settings
— This function is used to change the password for the menu » Settings «.
Select the menu items » Settings «, » Instrument «, » Passwords « and

» Password Cfg. « in this order, pressing the »
tion.
Select the line for password input and press the »

mode.
Use the » « and »

press the » « key to confirm the setting.
OK
Press the » « key to confirm the complete password.

OK
Date and time
— This function is used to set the date and / or time.
Select the menu items « Settings «, « Instrument « and « Date and time «

in this order, pressing the »
Select the desired input line (Date or Time) and press the »

switch to edit mode.
Use the » « and »

to confirm the setting.
« key after each selection.
OK
« keys to set each position of the password and
M
« keys to set each position of the password and
M
« key after each selection.
OK
« keys to set the value and press the »
M
« key to activate.
OK
« key after each selec-
OK
« key to switch to edit
OK
« key after each selec-
OK
« key to switch to edit
OK
« key to
OK
« key
OK
The menu » Settings «
67