Remote Sensor - Dräger Polytron 7000 Instructions For Use Manual

Installing accessories

Remote sensor

Intended use
Remote Sensor Adapter Polytron 7000 - 83 17 275:
— For installation of the sensor at a distance of up to 30 m from the
Polytron 7000 transmitter.
Remote Cable + Sensor plug 5 m Polytron 7000 – 83 17 270Remote Cable +
Sensor adapter, 15 m Polytron 7000 – 83 17 998,
Remote Cable + Sensor plug 30 m Polytron 7000 – 83 17 999:
The cable of the remote adapter may be shortened at the end with the con-
nector. The cable may not be extended. The use of a different cable is not
permitted!
If a Remote Sensor Adapter with sensor is used on a transmitter installed in
accordance with device category 3:
Remove the Category 1 marking from the transmitter. After being installed in
the manner described here, the accessory may never be used in explosion-
hazard areas of zone 0 or zone 1 (device category 1 or 2)! Explosion hazard!
If a Remote Sensor Adapter with sensor is used on a transmitter installed in a
non-explosion-hazard area:
Remove the explosion-protection marking from the transmitter. After being
installed in the manner described here, the accessory may never be used in
explosion-hazard areas! Explosion hazard!
Wall mounting
1 Drill the holes for the mounting plate. (A drilling template is provided for this
on page 141). The mounting holes are 50 ±4 mm apart.
Screw the mounting plate of the remote sensor adapter to the wall at the

desired position.
2 Slide the case of the remote sensor on to the mounting plate until it snaps
into position.
Installing the sensor
3 Unscrew the bayonet ring from the transmitter and remove the blanking
disc.
Remove sensor from packaging.

Insert the sensor in the opening with the "Dräger" logo pointing to the front.

Secure the sensor with the bayonet ring.

28
CAUTION
CAUTION
CAUTION
1
1
2
3