Adding Cisco Telepresence Systems (Cts) In Scopia Management - RADVision Scopia TIP Gateway Deployment Manual

Adding Cisco Telepresence Systems (CTS) in Scopia Management

About this task
You must manually add telepresence systems to Scopia Management. A telepresence system consists
of one segment or three segments, depending on the model, to allow participants to see each other as if
they were in the same room. For more information about telepresence systems, see the Administrator
Guide for Scopia Management.
When configuring telepresence, note the following restrictions and guidelines:
• Telepresence endpoints cannot be associated with a specific user.
• Telepresence endpoints cannot be set as VIP (an important endpoint whose video resolution is not
scaled down to below HD quality even when the available effective bandwidth is less than optimal).
• In cascaded meetings, telepresence endpoints always connect to the Master MCU. For more
information about cascaded meetings, see the Administrator Guide for Scopia Management.
Procedure
1. Access the Scopia Management administrator portal.
2. Select the Endpoints tab.
3. Select Add > Add manually.
4. Select the Cisco telepresence system in the Type list.
Deployment Guide for Scopia TIP Gateway Version 8.2
Figure 29: The CTMS Static Meetings page
The Add Endpoint window appears.
Configuring your Scopia Solution for Interoperability with Cisco
Telepresence | 46