RADVision Scopia TIP Gateway Deployment Manual page 37

5. Enter or modify the basic settings for your device, as described in
Deployment Guide for Scopia TIP Gateway Version 8.2
Figure 23: Adding a new video network device
• To modify the basic attributes of the device, select the link of the device in the Name
column, and select the Configure tab if present.
device's basic settings. Scopia Management then connects to the devices and retrieves
additional information, such as the version number.
Table 5: Configuring your device's basic settings
Field Name
Name
IP Address
Location
Figure 24: Adding a new gateway
Enter the name used to identify the device. This name will be
displayed in the list of devices.
Enter the device's management IP address, as configured
during device installation.
This is only relevant for service providers or deployments
with multiple locations.
Select the device's location.
Configuring your Scopia Solution for Interoperability with Cisco
Table 5: Configuring your
Description
Telepresence | 37