Table of Contents
Advertisement
Verifying the Scopia TIP Gateway Installation
About this task
After you installed the device and performed its initial configuration, you need to verify that it is installed
and configured correctly.
Procedure
1. On the front panel, verify that the power LED is lit green.
Deployment Guide for Scopia TIP Gateway Version 8.2
Figure 17: Configuring the MCU throughput
Important:
To access the web interface, you need an IP address as explained in
Device IP Addresses
on page 25.
Configuring the
Setting up the Scopia TIP Gateway | 28
Advertisement
Table of Contents
