Table of Contents
Advertisement
5. Select OK to save your changes.
6. You can modify these settings at any time by selecting the device name link in the SIP
Adding the CTMS to Scopia Management
About this task
Though the TIP Gateway allows to connect Cisco Telepresence Systems directly into a conference on
the Scopia Elite MCU, it also supports connecting these endpoints through the CTMS for organizations
using this Cisco MCU in their deployment.
When working in a CTMS environment, you actually create a cascading link between two MCUs, where
local participants connect to their local MCU, and the conference is cascaded by connecting between
the MCUs using a fraction of the bandwidth compared to the centralized deployment.
Setup Scopia Management as follows:
• For calls outbound to Cisco telepresence, configure the CTMS information which consists of a
route pattern and service number.
For example, a routing pattern might define the dial prefix '227' to route the call to the CTMS, and
'5678' as the service number. Scopia Management would send to the CTMS a dial string that
includes the number 227-5678.
• For calls inbound from Cisco telepresence, configure the CTMS Directory Number.
For example, the number '1000-8825' would be sent from the Cisco telepresence. Scopia
Management would interpret the number '1000' as originating from the CTMS, and '8825' as the
MCU service/conference number to which it should send the call.
Important:
The CTMS is considered as an endpoint in the Scopia Management setup.
Deployment Guide for Scopia TIP Gateway Version 8.2
Field Name
Port
Enter the port used for SIP connections. The default port is 5060 for
TCP/UDP, and 5061 for TLS.
Transport Type
Select the transport protocol used for connecting to the CUCM (SIP
server), according to the selected port number. If the default port is
5060, select TCP/UDP; if it is 5061, select TLS.
Model
Select Cisco Call Manager from the list.
Location
Select the location of the SIP server.
This field is only relevant for distributed or service provider
deployments.
SIP Domain
Enter the domain name of the CUCM (SIP server) network. For
example, if the FQDN is <SIP server name>.companyname, the SIP
domain is 'companyname'.
Servers list.
Description
Configuring your Scopia Solution for Interoperability with Cisco
Telepresence | 42
Advertisement
Table of Contents
