Checking The Accessories Required For Mounting - RADVision Scopia TIP Gateway Deployment Manual

Procedure
1. Read
2. Prepare masking tape or a felt-tip pen to mark the location of the device-fixing cage nuts. If
3. If you choose to mount the shelf, see the manufacturer's guidelines for mounting a shelf.
4. Ensure the shelf is positioned horizontally in the rack.
5. Ensure the rack breaks are locked or the rack is stabilized.

Checking the Accessories Required for Mounting

Check you have the accessories necessary for mounting the device (see
for mounting
• 2 mounting brackets (left and right)
• 2 cage nuts (M6) each with its hexagon socket cap screw (M6x10, DIN 7984)
• 4 Phillips screws already mounted on the device.
Deployment Guide for Scopia TIP Gateway Version 8.2
Verifying Rack Suitability
information.
the holes on the rack are marked with numbers, write down the numbers on a piece of paper.
When looking for a location on the rack (see
• Choose a shelf on a rack with at least 1.73 inches (4.4 cm) of empty space above.
• Verify that the shelf you want to use is properly mounted and secured.
• Verify that the shelf can support the device weight. See .
• Verify a hole is present 0.75 inches (2 cm) above the shelf (measured from the center
of the hole).
Figure 7: Checking the location of the shelf in the rack
on page 20):
on page 15, which contains important positioning and spacing
Locating a Shelf in the Rack on page 18):
Figure 8: Accessories required
Setting up the Scopia TIP Gateway | 19