RADVision Scopia TIP Gateway Deployment Manual page 71

Encrypting communications between the gateway and Scopia Management is typically less
common since they are usually both located behind the firewall inside an enterprise.
This section details how to encrypt communications between the Scopia Gateway and the video
network.
To encrypt control and management communications between Scopia Management and the SIP and
H.323 networks, see
Procedure
1. Access the Scopia Management administrator portal.
2. Select Devices > Devices by Type > Gateways.
3. Select the gateway you require.
4. Select the Configure tab.
5. For encrypting communications between the gateway and the SIP network , select one of
6. For encrypting communications between the gateway and the H.323 network, especially the
Deployment Guide for Scopia TIP Gateway Version 8.2
Important:
Enabling the TLS Connection in Scopia Management
these settings for the Service Encryption field:
Table 10: Configuring the encryption
Field Name
Best effort
Mandatory
MCU, proceed as follows:
a. Select Advanced Parameter Settings.
The Advanced Parameters dialog box appears (see
support on page 72).
b. Type h235callssupport in the Command ID field.
c. Clean the Value field.
d. Select Get.
Scopia Management automatically sets the port's value to 1 in the Value field.
on page 72
Description
When selected, indicates the gateway
supports encryption. If the remote site does
not support it, communications are not
encrypted.
Communications are always encrypted. If the
remote site does not support encryption,
communications fail.
Figure 51: Enabling H.235 call
Securing Your Video Network Using TLS | 71