Marking The Location Of The Device-Fixing Cage Nuts - RADVision Scopia TIP Gateway Deployment Manual

Figure 9: Removing the Phillips screws on the side panel
3. Attach the brackets on each side of the device side panel with the Phillips screws. See Figure
10: Aligning the bracket with the Scopia TIP Gateway front panel on page 21.
Figure 10: Aligning the bracket with the Scopia TIP Gateway front panel

Marking the Location of the Device-fixing Cage Nuts

About this task
There is a pair of cage nuts, one for each front-facing rack post. You need these cage nuts to fix the
device brackets to the post.
Deployment Guide for Scopia TIP Gateway Version 8.2 Setting up the Scopia TIP Gateway | 21