Adding Cisco Telepresence Systems (Cts) In Scopia Management - RADVision SCOPIA TIP Deployment Manual

Adding Cisco Telepresence Systems (CTS) in SCOPIA Management

You must manually add telepresence systems to SCOPIA Management. A telepresence system
consists of one segment or three segments, depending on the model, to allow participants to
see each other as if they were in the same room. For more information about telepresence
systems, see the Administrator Guide for SCOPIA Management.
When configuring telepresence, note the following restrictions and guidelines:
Procedure
Step 1
Step 2
Step 3
Step 4
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0
b. Write down the relevant call-in numbers to the CTMS meetings as you need them for
configuring the CTMS prefix in SCOPIA Management.
For more information, see
Figure 5-11
•
Telepresence endpoints cannot be associated with a specific user.
•
Telepresence endpoints cannot be set as VIP (an important endpoint whose video
resolution is not scaled down to below HD quality even when the available effective
bandwidth is less than optimal).
•
In cascaded meetings, telepresence endpoints always connect to the Master MCU. For
more information about cascaded meetings, see the Administrator Guide for SCOPIA
Management.
Access the SCOPIA Management administrator portal.
Select the Endpoints tab.
Select Add > Add manually.
The Add Endpoint window appears.
Select the Cisco telepresence system in the Type list.
"Adding the CTMS to SCOPIA Management" on page 34
The CTMS Static Meetings page
Configuring your SCOPIA Solution for Interoperability with Cisco Telepresence | 38