Technical Specifications - RADVision Scopia TIP Gateway Deployment Manual

Technical Specifications

This section lists important information about the device you purchased. Refer to this information when
preparing system setup and afterwards to verify that the environment still complies with these
requirements.
• System power requirements:
–
• Power consumption:
–
• Environmental requirements:
–
–
–
• Physical dimensions:
–
–
–
• Interfaces
–
–
–
• Ethernet connection requirement:
–
• Communications:
–
–
–
• Supported audio codecs:
–
• DTMF Translation:
–
• Video support:
–
–
• Content Sharing
–
• Call capacity:
Deployment Guide for Scopia TIP Gateway Version 8.2
100-240V AC input, 50/60Hz auto-switched
350W with 3A of standby current, which meets the SSI EPS 12V specification
Operating temperature: 10°C to 30°C (50°F to 86°F)
Humidity: 90% non-condensing at 35°
Storage and transit temperature: -40°C to 70°C (-40°F to 158°F), ambient
Size: 430mm (16.9") width x 43mm (1.7") height x 508mm (20") depth
Weight: 15kg (33lbs) maximum
19-inch rack-mountable with flanges
2 x RJ-45 gigabit Ethernet (rear)
1x DB9 serial port (rear)
4 x USB 2.0 ports (rear)
1Gbps
H.323 and TIP
IPv4
Bit rate: up to 2.25Mbps per segment. See also "Call capacity" in this topic.
AAC-LD, G.722, G.722.1, G.711 A-Law/µ-Law
In-band to out-of-band translation
Video codec: H.264
Video resolution: 720p at 30fps
H.264, XGA at 5fps
About Scopia TIP Gateway | 7