7. Select H264 in the video codec list so that the service supports the same video codec as the
8. Select OK.
Defining Allowed Bandwidth in the MCU
About this task
Make sure the bandwidth is configured to more than 1Mbps, which is the value required for the Cisco
telepresence. A value under 1Mbps causes the videoconference to disconnect.
Procedure
1. Access the MCU administrator interface.
2. Select Configuration.
3. Select Conferences.
4. Locate the Services list section.
5. Select the Review button
6. Make sure that the required value is set to 1024 Kbps as a minimum in the list under Max
7. Select Apply.
Deployment Guide for Scopia TIP Gateway Version 8.2
Figure 31: Enabling presentation in an MCU service
Cisco devices.
call rate (Kbps).
next to the required service.
Figure 32: Adjusting the bandwidth
Configuring your Scopia Solution for Interoperability with Cisco
Telepresence | 49