Table of Contents
Advertisement
Chapter 5 | Configuring your Scopia
To configure your video network for Cisco telepresence, you need to configure the following deployment
components: Scopia TIP Gateway, Scopia Management, and Scopia Elite MCU. You also need to confirm that the
CUCM, Cisco's Call Manager, is properly configured for the Scopia Solution.
Important:
Only the personnel that installed the Cisco telepresence and the customer's network administrator can modify the
Cisco telepresence configuration.
Scopia Management does not require any specific license for supporting telepresence but is aware of the MCU
telepresence license to deliver warning messages to administrators and for display purposes.
This section guides you through the steps required to integrate Cisco telepresence with Scopia Solution, as follows:
Navigation
1.
Verifying the CUCM Settings for Scopia Management
2.
Configuring Ports on the Scopia TIP Gateway
3.
Configuring the Scopia TIP Gateway in Scopia Management
4.
Configuring Cisco Telepresence in Scopia Management
5.
Configuring Scopia Elite MCU for Cisco Telepresence
Verifying the CUCM Settings for Scopia Management
About this task
The Cisco Unified Call Manager (CUCM) can be configured as a SIP proxy with Scopia Solution's
components by defining a SIP trunk from the CUCM to the SCOPIA Management, and defining routing
patterns which are aligned with the overall dial plan of the network.
Perform this procedure to confirm the SIP trunk includes the special settings required for routing video,
audio, and data to the Scopia Solution.
Caution:
Only the personnel that installed the Cisco telepresence and the customer's network administrator
should modify the Cisco telepresence configuration.
Deployment Guide for Scopia TIP Gateway Version 8.2
Solution for Interoperability with
Cisco Telepresence
on page 31
on page 30
on page 36
on page 41
on page 48
Configuring your Scopia Solution for Interoperability with Cisco
Telepresence | 30
Advertisement
Table of Contents
