Configuring Rtp/Rtcp/Srtp Ports On The Scopia Tip Gateway - RADVision Scopia TIP Gateway Deployment Manual

5. Select Advanced Parameters. The Advanced Parameters dialog box appears (see
6. To set the base port for the H.245 control channel protocol, do the following:
7. To set the port range for H.245, do the following:
Deployment Guide for Scopia TIP Gateway Version 8.2
Figure 22: Configuring a gateway from Scopia Management
22: Configuring a gateway from Scopia Management
a. Clear the values before proceeding to the next step.
b. Enter h245baseport in the Command ID field.
c. Enter the port value in the Value field.
d. Select Save.
e. Select Close
a. Clear the values before proceeding to the next step.
b. Enter h245portrange in the Command ID field.
c. Enter the port value in the Value field.
d. Select Save.
e. Select Close
on page 33).
Configuring your Scopia Solution for Interoperability with Cisco
Figure
Telepresence | 33