Table of Contents
Advertisement
Configuring the Scopia TIP Gateway in Scopia Management
About this task
This section explains how to configure the , Scopia TIP Gateway settings in Scopia Management.
Since the Scopia Gateway does not have its own web interface, its configuration is performed in Scopia
Management.
Scopia Management and gateways communicate in XML over TCP for control and configuration
commands. You can secure the connection by configuring it to the TLS protocol. Make sure to generate
the Scopia Management and Scopia Gateway certificates before configuring the connection to TLS (see
Securing Your Video Network Using TLS
Before you begin
Procedure
1. Access the Scopia Management administrator portal.
2. Select the Devices > Devices by Type > Gateways.
3. Select the Scopia Gateway you are configuring.
4. Select the Configure tab.
Deployment Guide for Scopia TIP Gateway Version 8.2
Field Name
Model
Registered GK
Description
This field is only necessary when adding gatekeepers and
gateways:
• If adding a gatekeeper profile, select the gatekeeper's
vendor and model from the list.
• If adding a gateway profile, select the gateway type
from the list.
Select the gatekeeper to which the telepresence system is
registered to from the list.
If you select None, the endpoint can be added to Scopia
Management but will not be connected until you register the
endpoint with the gatekeeper, and select the gatekeeper
here.
on page 51).
Configuring your Scopia Solution for Interoperability with Cisco
Telepresence | 38
Advertisement
Table of Contents
