Restoring The Previous Software Version Of A Network Device - RADVision Scopia TIP Gateway Deployment Manual

Restoring the Previous Software Version of a Network
Device
About this task
This section explains how to restore a previous software version after you upgrade your network device.
You can restore the same software version only once.
During this procedure the network device shuts down for a few minutes causing all active calls to be
disconnected.
Some parameters are not backed up and cannot be restored:
• IP address
• IP mask
• Default router IP address
• MTU size - the size of the packets received from the gateway
• DNS suffix
• DNS primary address
• DNS secondary address
Procedure
1. Access the Scopia Management administrator portal.
2. Search for an online network device as explained in .
3. Select Devices > Devices by Type > Gateways.
4. Select the network device whose software version you want to restore.
5. Select Manage > Restore Previous Version.
6. Select Yes in the confirmation message.
Deployment Guide for Scopia TIP Gateway Version 8.2
The system informs you that all active calls on the device will be disconnected when you
begin the process.
The Update Log window opens showing the task progress
a software package on page 78).
(Figure 56: Progress of restoring
Performing Maintenance Procedures | 77