Navigation
•
Limiting TCP Port Range for H.245 on the Scopia TIP Gateway
•
Configuring RTP/RTCP/SRTP Ports on the Scopia TIP Gateway
•
Configuring UDP Port for RAS on the Scopia TIP Gateway
•
Configuring TCP Port for Q.931 on the Scopia TIP Gateway
Limiting TCP Port Range for H.245 on the Scopia TIP Gateway
About this task
The Scopia TIP Gateway designate ports 1024-1174 for H.245 (signaling). H.245 is a control protocol
used for multimedia communications that enables transferring information about the device capabilities,
as well as opening/closing the logical channels that carry media streams. To provide additional security
for your firewall, you can limit this range.
Procedure
1. Log in to the Scopia Management administrator portal.
2. Select Devices > Devices by Type > Gateways.
3. Select the relevant gateway from the Gateways list.
4. Select the Configure tab (see
Deployment Guide for Scopia TIP Gateway Version 8.2
on page 33).
on page 34
on page 35
Figure 22: Configuring a gateway from Scopia Management
Configuring your Scopia Solution for Interoperability with Cisco
on page 32
on page 33
Telepresence | 32