Removing The Cage Nut Screws - RADVision Scopia TIP Gateway Deployment Manual

Before attaching the cage nuts to the rack, mark where you plan to attach them, so you can be sure they
are level and properly placed.
Procedure
1. From inside the front-facing rack post, mark the location of the device-fixing cage nut
2. Repeat this procedure for the other front-facing post.

Removing the Cage Nut Screws

About this task
The cage nuts are supplied with pre-mounted screws. Remove the screws and put them aside for later.
See Figure 12: Removing the cage nut screw
Deployment Guide for Scopia TIP Gateway Version 8.2
measured at 0.75 inches (2 cm) above the shelf. See
device-fixing cage nut on the rack
Figure 11: Marking the location of the device-fixing cage nut on the rack
Figure 12: Removing the cage nut screw
Figure 11: Marking the location of the
on page 22.
on page 22.
Setting up the Scopia TIP Gateway | 22