Table of Contents
Advertisement
Configuring Cisco Telepresence in Scopia Management
For general information about telepresence systems, see the Administrator Guide for Scopia
Management.
For information on the telepresence deployment, see
page 9.
These procedures describe the planning and configuration of telepresence in Scopia Management.
Navigation
•
Adding the CUCM to Scopia Management
•
Adding the CTMS to Scopia Management
•
Adding Cisco Telepresence Systems (CTS) in Scopia Management
Adding the CUCM to Scopia Management
About this task
To enable Scopia Management to operate with Cisco telepresence, configure Scopia Management with
the CUCM which is the call manager to which Cisco telepresence endpoints are registered. For the
Scopia Solution, the CUCM acts as a proxy SIP server.
You can view the connection status between Scopia Management and the CUCM (SIP server) by
navigating to Devices > SIP Servers.
Procedure
1. Access the Scopia Management administrator portal.
2. Select the Devices tab.
3. Select SIP Servers in the sidebar.
4. Configure the SIP server settings in the Basics section, as described in this table.
Deployment Guide for Scopia TIP Gateway Version 8.2
c. Select Apply.
Table 7: Configuring the CUCM settings
Field Name
Name
Enter a name to identify the CUCM (SIP server). This name is
displayed in the list of SIP servers.
IP Address/ FQDN
Enter either the network name (FQDN) of the computer that you are
using as the CUCM (specify all domain levels), or the CUCM's IP
address.
Planning your Topology for the TIP Gateway
on page 41
on page 42
on page 46
Description
Configuring your Scopia Solution for Interoperability with Cisco
on
Telepresence | 41
Advertisement
Table of Contents
