Configuring Cisco Telepresence In Scopia Management; Adding The Cucm To Scopia Management - RADVision SCOPIA TIP Deployment Manual

Hide thumbs Also See for SCOPIA TIP:

Table of Contents

Step 7

Configuring Cisco Telepresence in SCOPIA Management

For general information about telepresence systems, see the Administrator Guide for SCOPIA

Management.

For information on the telepresence deployment, see

Gateway " on page

These procedures describe the planning and configuration of telepresence in SCOPIA

Management.

To enable SCOPIA Management to operate with Cisco telepresence, configure SCOPIA

Management with the CUCM which is the call manager to which Cisco telepresence endpoints

are registered. For the SCOPIA Solution, the CUCM acts as a proxy SIP server.

You can view the connection status between SCOPIA Management and the CUCM (SIP server)

by navigating to Devices > SIP Servers.

Procedure

Step 1

Step 2

Step 3

Step 4

RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0

Allow SCOPIA Management to access the SCOPIA Gateway:

Select the Access tab.

Enter the login name and password of the SCOPIA Gateway. The default username is

admin and the default password is password.

Select Apply.

•

Adding the CUCM to SCOPIA Management ............................................... page 33

•

Adding the CTMS to SCOPIA Management ............................................... page 34

•

Adding Cisco Telepresence Systems (CTS) in SCOPIA Management .................. page 38

Access the SCOPIA Management administrator portal.

Select the Devices tab.

Select SIP Servers in the sidebar.

Configure the SIP server settings in the Basics section, as described in this table.

"Planning your Topology for the TIP

Configuring your SCOPIA Solution for Interoperability with Cisco Telepresence | 33

Table of Contents