3D Model Exposure; Calibrating X-Ray Unit For Impression Or Plaster Material - Planmeca ProMax 3D S User Manual

15

3D MODEL EXPOSURE

15.1

Calibrating X-ray unit for impression or plaster material

Impression material
Calibration cup
(part number 10031325)
User's Manual (3D)
CAUTION The 3D Model programs must not be used
for patient imaging. The programs are
intended
impressions and plaster casts only.
NOTE The programs are not available for Planmeca ProMax
3D s units.
NOTE The X-ray unit has to be calibrated for each new
material that is used. The X-ray unit needs to be
calibrated only once for each material.
NOTE FOR IMPRESSIONS
Only monophase impression materials can be used.
NOTE FOR PLASTER CASTS
If the plaster cast consists of two materials, the X-ray
unit has to be calibrated for the teeth material.
Insert material into the calibration cup provided (part
number 10031325) until the calibration cup is full.
Place
10031265) in the material. Note that the calibration pin
has to be pushed in thicker end first. The middle rim has
Calibration pin
to be flush with the top edge of the calibration cup.
(part number
10031265)
Let the material set. The setting time will depend on the
material used. Wait slightly longer than recommended in
the instructions supplied by the manufacturer to ensure
proper hardening.
Remove all excess material from the top of the calibration
cup. Then gently pull the calibration pin out and ensure
that the surfaces of the hole formed by the calibration pin
are even (no air bubbles in inside walls).
3D MODEL EXPOSURE
for taking
the calibration pin
Planmeca ProMax 3D s / 3D 71
exposures
provided (part number
of