Planmeca ProMax 3D S User Manual page 39

User's Manual (3D)
• Return C-arm after exposure
Touch the Return C-arm after exposure field to set
the X-ray unit so that the C-arm will automatically
return to the starting position at the end of an
exposure cycle.
Note, however, that the automatic function works
only if the exposure button is pressed and held
down for the entire duration of the exposure.
• Disable Entry 1 position
Select this option if you need to disable Entry 1
position. This might be necessary if there is no
space for the C-arm to move back.
• Statistics
Touch the Statistics field to set the X-ray unit so
that the radiation dose will be shown in a pop-up
window after
measures the highest radiation dose the patient is
exposed to during exposure. Note that if the patient
does not cover the whole exposure area (e.g.
cephalometric exposure) the real patient dose is
lower.
Radiation dose is indicated in terms of DAP (Dose
Area Product). The measurement unit for DAP is
mGy*cm².
• Enable midsagittal & Frankfort lights in Tomo
Select this option to set the X-ray unit so that also
the midsagittal and Frankfort lights come on in
tomographic and 3D programs when the patient
positioning lights are switched on.
• Disable temple supports
Select this option if you need to disable the temple
supports.
• Use Dimax sensor for panoramic
Select this option if you want to use a 3D s / 3D
sensor for taking 3D images and a Dimax sensor
for taking panoramic (and tomographic and
cephalometric) images.
When the option is not selected (check box empty)
you can take 3D and SmartPan (SmartPan,
SmartTMJ, SmartSinus) images with the same
sensor.
NOTE: This option will be shown only if the X-ray
unit has a 3D s / 3D sensor and a SmartPan
license. The SmartPan license is activated as
described in section
(i310)" on page 39.
The selected option(s) will be marked with a green check
mark. To deselect a function, touch the field again. The
green check mark will disappear.
Confirm your selection(s) by touching Done. Touching the
Cancel field will bring you back to the User preference
settings (i200) display.
Planmeca ProMax 3D s / 3D 35
INFORMATION DISPLAYS
each exposure. The
"Enable / disable features
program